Rig Welder Forums  

Go Back   Rig Welder Forums > Members List

Tomkat Tomkat is offline

Senior Member

Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. Charlie
    03-28-2016 05:13 PM
    Hey Tom....started @ Marshalltown last Monday waledin hangers. Great entertainment so far lmao. Thanks again for the lead
  2. WELDO
    01-15-2015 07:41 PM
    Hey thanks for the comps Tomkat! See you have it goin on too brother. Looks good ;-)
  3. Charlie
    03-09-2014 03:22 PM
    Set varible voltage or arc selector on high. Some have numbers, some go incrementally from special applications to vertical & overhead to flat welding/large electrodes (thats the high end) It doesnt matter where the continuous range selector (amps) is set. The max OCV's at a certain rpm should be on the faceplate. Remember the max is what it is and seldom ever needed. Dont be afraid to slow it down some & save some fuel. Check your aux power volts as well. Below 100 will hurt some grinders. You will find that machine to be an excellent downhiller
  4. Tomkat
    03-08-2014 06:47 AM
    Were should the dials be positioned on a SAE400 to dial in OCV


Total Posts
Visitor Messages
General Information
  • Last Activity: 10-11-2019 02:53 PM
  • Join Date: 10-27-2013


Showing Friends 1 to 2 of 2

All times are GMT -7. The time now is 07:44 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.